Reaction Vessel Lid Only, 8-Neck PTFE, 200mm, w/ou

REACTION VESSEL LIDS, PTFE, 200MM

Reaction vessel lid is constructed entirely of PTFE. Low-form lid has eight openings: (A) center neck 1” female NPT for PTFE standard taper adapter, (B) side necks 1-1/2” female NPT, vertical for PTFE standard taper adapters, (C) side neck 1” female NPT with 10° X 10° compound angle for PTFE compression fitting used with Lasentec® Probe, (F) side neck 1-1/2” female NPT, vertical for PTFE standard taper adapter, (E) side neck 1-1/2” female NPT angled 10° for powder addition, and (D) side necks 1/2” female NPT. Lid is supplied complete with listed PTFE standard taper adapters for center and vertical side necks, 19mm or 25mm PTFE compression fitting for 10° X 10° compound angle side neck, PTFE standard taper adapter for angled powder addition port, and two 1/2” male NPT PTFE plugs. For clamp see CG-141 or CG-141-T. For o-ring see CG-147. Special neck sizes and configurations are available.

Lasentec® is a registered trademark of Mettler Toledo.